Did You Know...?

All of our
license plate brackets
are designed and
manufactured
so they screw into
the existing
license plate
mounting locations
in the Subaru bumpers.
Subaru provides dimples
in the front bumper
for the mounting of
license plates.
These dimples are not
holes until you screw
into them with our
supplied screws
which have a very
sharp point designed
to create the
opening required
to gain access to
the factory-installed
fasteners.
Subaru does not
open these holes
because there are
states that
do not require
front license plates.

So, when you order our
front license plate bracket,
you can easily
use the dimples
as the location
into which to mount
this product.
Not only does that
make installation easy,
it preserves the
integrity of your
model's design.

Note: Some Subaru models have
holes in the front bumper,
(some square, some round,)
which are for non-U.S. plates.
These holes are not used
in the installation
of this product.
You will notice that on those
models, the dimples are
found in the area
between the
non-U.S. holes in
the center of the bumper.
And once installed,
the front license plate
bracket will cover up
any non-U.S. holes,
giving your vehicle
a clean, sleek,
finished appearance.

– Made in the USA –
A Quality
Aftermarket Accessory
Manufactured by
C&C Car Worx Corp.